Pull the paper feed shaft toward the rear of the primary paper feed unit in the direction of the arrow and remove the paper feed pulley. Hard disk unit Figure 3. When a problem is detected, printing is disabled. While holding down the projection, slide the Transfer roller assembly transfer roller assembly toward the front to remove it. Cleaning brush Figure Connecting the printer to the computer.
|Date Added:||9 November 2014|
|File Size:||55.23 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Open the front cover. U Performing fine adjustment of the motor speed Description Performs fine adjustment of the speeds of the motors.
Figure Connecting the printer to the computer. If you install a hard disk, however, mount the network interface card to the upper slot OPT2.
Placing the proper location. Service personnel are advised to read this booklet carefully to familiarize themselves with the warnings and precautions described here before engaging in maintenance activities. Label Figure Page 40 Bit 0: MP paper feed shaft Figure U Setting finisher stack quantity Description Sets the number of sheets of stack on the intermediate tray in the optional finisher. Version ID code for Kyocera Purpose To check or change the developing bias and transfer voltage.
If the display shows the message requesting toner replenishment, replace the cartridge. Cs-9520dn the same time, feed clutch 1 FCL1 turns on for 30 ms.
Hard disk unit Figure 3. Printer Media Media Load Type. Install the waste toner box as shown in the figure. Also during paper feed, the MP separation pulley prevents multiple sheets from being fed at one time by the torque limiter.
Poor contact in the cooling Reinsert the connector.
Remove the press roller and fuser heater M and S see pages Page At the same time, feed clutch 1 FCL1 turns on for 30 ms. Kyocera KM User Manual pages.
If none, replace cooling fan Cooling fan motor 6 coil. Tape Tapes Figure Tape 4. Check if the following electromagnetic Correct.
U Adjusting margins of image printing Description Adjusts the margins of image printing for feeding from the upper cassette of the printer. Check if the paper meets specifications. Raise the MP paper feed shaft as shown in Stop ring the illustration, remove the stop ring, and then remove the MP paper feed pulley.
High risk of serious bodily injury or death may result from insufficient attention to or incorrect compliance with warning messages using this symbol.
Toner container Figure 5. By pressing ‘print’ button you will print only current page.
Remove the two screws holding the front left cover and then the cover. Purpose To prevent image loss that occurs depending on the difference of paper type. Waste toner box 2.
Connecting the printer to the computer. The service mode is intended for use by the service person for maintenance and service for the items explained in the following sections. Paper feed motor PFM